VideoComm Technologies ZX-480SR40 Owner's Manual download pdf (Page 17)

5.8GHz Day-Night Camera Series Manual Rev. A

Possible Solutions if Experiencing Interference

• Change the channel of your transmitter or move your wireless video devices farther away from the

source of interference. Transmitters do not have to be beside the camera source and the receivers do

not have to be beside the monitoring equipment.

• Before connecting the video feed into the transmitter, use a field monitor to check that you have a

good video picture. Similarly for the receiver, check the video output first before connecting to the

video feed into the monitor or recorder.

• Depending on the installation, use an existing building as a shield from interfering sources.

• Check power sources and video cable runs for possible ground loops problem, correct voltages, cable

kinks, impedance and proper termination. Ensure proper gauge of wire/cable is used for lengthy

video and power source installations.

• Whenever possible use separate regulated power supplies for separate devices.

• Mount your equipment at least 15 feet above the ground and increase the height if there are any

obstructions like a rooftop, cars in parking lots, metal fence or road traffic. If transmitting over a 10-

foot high fence, the transmitter and receiver should be at least 25 feet above the ground (15 feet

above the fence).

• Mount the transmitter and receiver on the edge of the roof and ensure it is looking away

from the building. This is particularly important if there is a metal roof that tends to

deflect signals down.

VideoComm Technologies

Customer Service

Bus (905)-339-0366

US Toll Free 888-379-2666

Fax (905)-339-1776

Web Site- www.VideoTransmitters.com

Monday - Friday 8:30am- 5:30pm

Eastern Standard Time

1 2 ... 12 13 14 15 16 17 18 19 20

No comments

VideoComm Technologies ZX-480SR40 Owner's Manual Page 17